Dobrodošli u Player svet! Prijavi se ili Registracija

ADAM AUDIO SUB20

ADAM AUDIO SUB20


Proizvođač: ADAM AUDIO SUB20
Dostupnost: Nema na stanju
Šifra Proizvoda: 50205
Prikazana cena je za komad.

ADAM subwoofers Our subwoofers are dedicated to ADAM Audio's primary goal: the best possible authenticity in the reproduction of music. For our subwoofers, this means combining power and precision while simultaneously avoiding "impressive" bass volume at the cost of accuracy. Their task is it to complement the highly acclaimed lucidity and transparency of the ADAM monitors in the lower and lowest frequencies. All subwoofers up to the Sub2100 feature both balanced (XLR) and unbalanced (RCA) in and output connectors, and numerous controls to adapt to different room acoustics and requirements. "I recommend it highly to anyone looking for a top-notch subwoofer." Tape Op on the Sub12 (Feb/March 2009) Panel/Controls All subwoofers up to the Sub2100 feature a number of controls to adapt to different room acoustics and requirements. All units have a level control that varies from -60dB to +6dB, a phase ±180° switch and variable upper frequency barrier control (50-150Hz), a switchable 85Hz high pass filter for the satellite output. In addition, there is a ‘signal-on/continuous' switch. This provides the option of automatic power up whenever the subwoofer receives a signal and automatic power off after 15 minutes of no signal. Sub20 The Sub20 and Sub24 are very powerful subwoofers designed for medium sized or larger control rooms in which powerful and yet accurate extra deep bass monitoring is required. The Sub20 is equipped with two long throw 10" drivers which are meant to reproduce LFE or other low frequency signals down to 25Hz. The Sub24, housing two long throw 12" drivers, extends down to 22Hz. The power of two subwoofers The Sub20 and Sub24 each have two drivers, which are mounted in chambers at opposite sides of the cabinet. Due to this alignment, the forces applied to the cabinet oppose each other and consequently compensate themselves, so that the cabinet stays much quieter than with conventional arrays. Distortion is drastically reduced in this manner, resulting in improved signal clarity, especially at higher levels. There are two down firing bass reflex tubes that, because of their size and construction, successfully avoid ventilation noise. PWM amplifers The amplifier section has two units, each capable of delivering 200W continuous or 300W peak power to their corresponding drive units. Both power supply and amplifier section use PWM technology, meaning very high efficiency (≥90%) and cool operation in even the most critical phases of operation. An additional output allows daisy-chaining as many Sub20s / Sub24s as desired. Subwoofer Number 2 Basket Ø 10" (260 mm) Voice coil Ø 2" (50 mm) Cone material Paper Built-in Amplifiers Subwoofer 2 Amp. power RMS / music 200 W / 300 W Input connectors Analog XLR / RCA General data Panel Rear Frequency response 25 Hz - 150 Hz THD > 60 Hz ≤1 % Max. peak ≥118 dB Crossover frequencies 50 - 150 Hz Input impedance 10 KOhm Weight 83.8 lb (38 kg) Height x Width x Depth 22" (560 mm) x 32" (810 mm) x 12" (300 mm) Warranty 5 Years Delivery contents Power cord, Manual


call

ADAM subwoofers

Our subwoofers are dedicated to ADAM Audio's primary goal: the best possible authenticity in the reproduction of music. For our subwoofers, this means combining power and precision while simultaneously avoiding "impressive" bass volume at the cost of accuracy. Their task is it to complement the highly acclaimed lucidity and transparency of the ADAM monitors in the lower and lowest frequencies.

All subwoofers up to the Sub2100 feature both balanced (XLR) and unbalanced (RCA) in and output connectors, and numerous controls to adapt to different room acoustics and requirements.

"I recommend it highly to anyone looking for a top-notch subwoofer." Tape Op on the Sub12 (Feb/March 2009)

Panel/Controls

All subwoofers up to the Sub2100 feature a number of controls to adapt to different room acoustics and requirements.

All units have a level control that varies from -60dB to +6dB, a phase ±180° switch and variable upper frequency barrier control (50-150Hz), a switchable 85Hz high pass filter for the satellite output. In addition, there is a ‘signal-on/continuous' switch. This provides the option of automatic power up whenever the subwoofer receives a signal and automatic power off after 15 minutes of no signal.

Sub20

The Sub20 and Sub24 are very powerful subwoofers designed for medium sized or larger control rooms in which powerful and yet accurate extra deep bass monitoring is required.

The Sub20 is equipped with two long throw 10" drivers which are meant to reproduce LFE or other low frequency signals down to 25Hz. The Sub24, housing two long throw 12" drivers, extends down to 22Hz.

The power of two subwoofers

The Sub20 and Sub24 each have two drivers, which are mounted in chambers at opposite sides of the cabinet. Due to this alignment, the forces applied to the cabinet oppose each other and consequently compensate themselves, so that the cabinet stays much quieter than with conventional arrays. Distortion is drastically reduced in this manner, resulting in improved signal clarity, especially at higher levels.

There are two down firing bass reflex tubes that, because of their size and construction, successfully avoid ventilation noise.

PWM amplifers

The amplifier section has two units, each capable of delivering 200W continuous or 300W peak power to their corresponding drive units. Both power supply and amplifier section use PWM technology, meaning very high efficiency (≥90%) and cool operation in even the most critical phases of operation.

An additional output allows daisy-chaining as many Sub20s / Sub24s as desired.

Subwoofer  
Number 2
Basket Ø 10" (260 mm)
Voice coil Ø 2" (50 mm)
Cone material Paper
Built-in Amplifiers  
Subwoofer 2
Amp. power RMS / music 200 W / 300 W
Input connectors  
Analog XLR / RCA
General data  
Panel Rear
Frequency response 25 Hz - 150 Hz
THD > 60 Hz ≤1 %
Max. peak ≥118 dB
Crossover frequencies 50 - 150 Hz
Input impedance 10 KOhm
Weight 83.8 lb (38 kg)
Height x Width x Depth 22" (560 mm) x 32" (810 mm) x 12" (300 mm)
Warranty 5 Years
Delivery contents

Power cord, Manual



Nazad na kategoriju Monitori