Vinyl sound can be significantly improved, when unwanted resonances between record and platter can be reduced, while playback. Therefore surfaces of record and platter should connect tigthly. Standard record pucks, that use weight to achieve this, have two disadvantages:

1) The weight can induce higher levels of rumble, when used with lower cost turntables which have less massive main bearings. This will affect the sound negatively.

2) Instead of the desired closer contact between your vinyl and turntable is often achieved the opposite: Due to the high weight in the middle of the plate arching the record and the edge loses contact with the turntable.

Clamp it is the real solution, an accessory with a clamp mechanism around the center spindle, that will not add weight, which would induce rumble. You can fine-adjust pressure according condition of your warped records. Fitting of Clamp it is easily done within seconds. This accessory will not only please your ears, its beautifully machined diamond-cut edges will also look extremely cool on any turntable!

Features

• Sound improvement for all turntables

• Reduces unwanted resonances while playback

• Fast and easy mounting

• Fine-adjustment of thightening force

• Full metal accessory with leather coating

• Diamond cut finish

The sound performance of a vinyl playback system can be significantly improved when all unwanted resonances between the record and the platter can be reduced during playback. To enable this, record clamps and pucks are used to hold the record tightly against the platter.

Standard record pucks, that use only weight to pin the record down, can have two disadvantages:

The weight can induce higher levels of rumble, when used with lower cost turntables which have smaller main bearings
With fragile records, you could introduce an unwanted "warping" effect.
Pro-Ject's Clamp-IT record clamp is the preferred solution for audiophile playback.

The Clamp-IT is a stylish accessory that sits over the centre spindle of a turntable and uses pressure to hold a record against the platter. The simple screw mechanism also allows you to adjust the pressure applied, depending on the condition of your warped records.

Not only does Clamp-IT improve your listening experience, as its beautifully machined diamond-cut edges will also stand out on any turntable!

Key Features:
Sound improvement for all turntables
Universal, thread-less locking mechanism
Reduces unwanted resonances during playback
Fast and easy mounting
Fine-adjustment of tightening force
Leather coating underneath protects record label
Diamond cut finish
Please Note: This clamp is incompatible with turntable models that have a threaded spindle (such as the 2 Xperience and 6 Perspex).